
Step 5: Power up the networking hub/switch that is between the the device you want to get into is in bridge mode that has only one LAN port from your primary NAT router. Step 4: Connect one wire to your primary NAT router to the networking hub/switch. Step 3: Connect one wire to the device you want to get into is in bridge mode that has only one LAN port to the networking hub/switch. Step 2: Disconnect the device you want to get into is in bridge mode that has only one LAN port from your primary NAT router.

If you do not have one already, I recommend a networking switch with Auto MDI-X so that you do not have to worry about the type of networking ethernet cable. Step 1: Get a networking hub/switch if you do not have one already. Q: But what if my router that is in bridge mode that I want to get access to has only one LAN Port? #6 The Wired NIC that you disconnected gets connected to one of the other LAN ports of the device that is in bridge mode. #5 Do not set a Default Gateway or edit the DNS Settings on your computer. #4 Based upon what you are trying to do, these settings will work. #2 The wired NIC gets disconnected from the Primary NAT router. To help you find that info out, you can use the guides at and you must know how to setup a manual Static IP on your computer. I know every single method to get into a device while it is in bridge mode.

One of the best reasons for DSL users for getting access to the modem so that they can get the dsl transceiver status (how strong the DSL signal is).

Users who connect the RJ-45 WAN port of their own (separate) NAT router who put their modem into bridge mode (not configured to handle a WAN IP), typically can not by default get access anymore to their modem's UI.
